
Flat Roof Repair
Base flashing, laps, and outlets on small flat storefront roofs, repaired with matching membrane.
Repair the flat roofPatagonia commercial roof repair for main street storefronts that share walls, where a leak often starts at the joint between one roof and the next building.


On a main street, buildings stand side by side, often at different heights. Where a lower roof meets the taller neighbor, the membrane turns up the wall under counterflashing.
That joint moves with heat and cold, and the counterflashing loosens. Water then runs behind it and shows up along the shared wall inside, often on plaster or an old tin ceiling. Fixing it means working at the line between two properties.
Small storefront roofs leak at the walls they share. Each row starts with what a shop owner sees.
Counterflashing pulled loose where your roof meets the taller building next door.
Reset and seal the counterflashing and repair the membrane turned up under it.
Gaps in the parapet cap on a wall shared by two storefronts.
Seal the cap joints, coordinating with the neighbor if the wall top is theirs.
Roof drained by a single scupper or downspout that is packed or undersized.
Clear the outlet and reseal its flashing; check whether water now drains freely.
Cracked pipe boot over a kitchen or restroom vent on a small flat roof.
Replace the boot and flash it into the membrane.
A skylight curb on a storefront roof with dried sealant and a cracked dome or panel.
Reseal the curb flashing and replace the cracked dome or panel to fit the existing curb.
An open lap in an older roof patched many times before.
Reseal the lap and record how many patches the roof carries for planning.
Patagonia storefront roofs protect shops, restaurants, and lodging along the main street.
Repairs at a shared wall happen from the roof, so the shop below stays open for business.
A sealed joint between two roofs stops water from crossing into either building.
Plaster, wood, and tin ceilings in older storefronts stay intact once the wall joint is sealed.
Fixing one joint early keeps the job within a simple repair instead of a re-roof needing a town permit.
Storefront roofs in Patagonia mostly need flat roof repair, with leak tracing when the stain sits away from the walls.

Base flashing, laps, and outlets on small flat storefront roofs, repaired with matching membrane.
Repair the flat roof
Tracing confirms whether a stain comes from your roof, the shared wall, or the neighbor's side.
Trace a storefront leakCall and tell us which wall and which neighbor. We will check the joint between the two roofs.
The trip out SR 82 is planned so most repairs finish in one visit. Inspect Your Roof comes first.


We check the joints along each shared wall, the parapet caps, the outlet, and any vent boots on the roof.
When the leak sits at a shared wall, we let you know which side owns the cap or counterflashing before work begins.
Membrane, counterflashing, and boots for the specific repair are loaded before the drive, so the job finishes in one visit.
Counterflashing gets reset and sealed, and the membrane under it is repaired up the wall.
After rain, the inside of the shared wall gets checked for new staining, and you receive photos.
About as long as the roof around it. New counterflashing on a sound wall joint can hold for years, while a patch on a sun-worn, brittle storefront roof fails sooner because the material next to it keeps cracking. Drainage, matching materials, and foot traffic all affect it.
The Town of Patagonia handles permits, with plan review by Santa Cruz County for larger work. Small flashing and seam repairs usually need no permit.
It depends on the property records and any agreement between owners. We show you where the leak starts so you and your neighbor can sort out the wall top if it is shared.
Yes. We bring ladders and set them where they stay clear of the sidewalk and shop entrance, tied off at the roof edge.
Many storefront roofs drain through one scupper or downspout. If it packs with debris or was set high, water stands until it evaporates.
Up to a point. When patches cover much of the roof and new leaks keep appearing between them, planning for replacement makes more sense than another patch.
Take dated photos of the stain and the wall, then call. We check the joint between the two roofs from your side and show you whether the water enters at your flashing or the neighbor's cap, so the right owner can arrange the repair.
Call as soon as you see water. Because the trip out SR 82 is planned around the specific repair, describing the stain, the wall, and the roof type on the first call lets us bring the right flashing, membrane, and boots and finish in one visit.
Yes. Repairs on older brick and adobe storefronts match the existing materials, especially where caps and flashing are visible from the street.
Tell us which wall or ceiling shows water. We plan the repair for one trip.
Leave a name and number and we will call you back about the leak, the seam, or the panel that has you worried.
Or call now: +1 (623) 310-0172